Think TWO! NDB-121 Resonator Supplement Manual

Before starting the activation preparations, ensure the following resonator conditions:

Under no circumstance operate a resonator under hypoglycemic conditions. This disrupts the device cycle and can lead to a Failure to Extract (FE) incident. This can kill you. Unwrap enclosed control rods A and B and insert into corresponding ports on the resonator. The product will not activate without these rods inserted. For V1M1-enabled devices, both rods must be inserted into the MON slots on the side of the device. Avoid accidentally inserting the rods into the AGI slots as they will get stuck. Collect epithelial material from the inner cheek using the provided swab. Insert swab into the supplied washing vial. Agitate swab for about 10 seconds. The mixture should be cloudy. Place the washing vial directly into the HISIā„¢ autoExtract and press down on the primary button until a snap is heard. Empty one capsule of NBD-121 into the resonator's primary receptacle, then aim the autoExtract nozzle at the receptacle while slowly squeezing the plunger with your thumb. Carefully apply drops of washed DNA prep onto the NBD-121 until it settles into a uniform tone. Allow to fully saturate for one minute. To verify proper alignment, touch the solution with one of the supplied indicator needles. Consult the testing graph below. The white tip should turn solid blue, indicating acceptable alignment. Weak, orange or zero coloration indicates poor cohesion. If this is the case, the product will not activate, and the chamber should be flushed immediately. When done, reseal the resonator receptacle and configure the release parameters. Refer to the table below for the optimal R, K and E-numbers for your NCI number. It is important to use the exact numbers stated in the cells, as deviating from these ranges could result in severe harm to the mind and body. After configuration, the resonator can be started. Ensure your space is calm and unobstructed, ideally lay on a bed. See further instructions below. Do not wait longer than 15 minutes before starting the device.



Solution Indicator Reference

Stable Unstable
Indication threshold





Release Parameters

NCI Tag (First 4 characters) R (Reading Vector) K (Keller Coefficient) E (Fine Exposure Interval)
00AA - FFFF 1.114243465 129 -120.113
NIAA - PIAA 1.114249345 129 -230.16
CIB0; CIB1.. 1.114287652 129 68.34
DULA - DPPP 8.2300210 316 23.32
C000 - C999 8.2300210 316 -30.58
CPX+; CPT+.. 8.2300210 115 -210.96